QUESTIONS ABOUT :

How to Drill a Door Lock

Mark the center of the doorknob holes using the template that came with your doorknobs. Install a 2 3/4-inch hole saw in your drill and tighten the chuck. Place the tip of the cent...
http://www.ehow.co.uk/m/how_6453839_drill-lock-set...
Load the 1/8-inch drill bit into the electric drill's chuck and tighten it into place. Line up the tip of the drill bit with the lock's key hole. Drill a 1-inch-deep hole between t...
http://www.ehow.co.uk/m/how_6059008_drill-open-loc...
Secure the door handle template from the door knob packet to the edge of the door you are going to use to latch the door. Center the template on the area where you will be cutting ...
http://www.ehow.co.uk/how_5626198_drill-door-handl...
Mark where the drill holes are going to go using a tape measure and a pencil. Double-check your measurements. Put the point of a large nail on the marks and tap it with a hammer fo...
http://www.ehow.co.uk/m/how_5858491_drill-fibergla...
Put on safety glasses to prevent small metal filings from flying into your eyes. Insert a new drill bit into the power drill. The drill bit should be 1/4 inch thick, and the power ...
http://www.ehow.co.uk/m/how_6195399_drill-open-dea...
Useful sites about:

How to Drill a Door Lock

Drill the lock - YouTube
8 Aug 2009 ... public service "lock out" turned in to a training "drill" ... Using a set of channel lock pliers to bang on the door knob to dent it up and scratch it to ...
www.youtube.com
How to Drill Open a Standard Door Lock | Destructables
4 Dec 2011 ... For my “Destructable” I will teach you how to drill open a standard door lock. For almost 9 years I worked as a locksmith. Usually when I tell ...
destructables.org
How to Drill a Lock: 9 Steps (with Pictures) - wikiHow
If you drilled correctly, the locking mechanism will turn, and you will gain entry to the previously locked door. If the lock still will not turn, you may need to destroy ...
www.wikihow.com
Popular Searches
Try these