QUESTIONS ABOUT :

Tillotson Carburetor Settings

Pull the rubber grommet covering the mixture screw. Start the Vespa. Allow it to run for 15 to 20 minutes to warm up the engine. Quickly turn the throttle of the Vespa halfway and ...
http://www.ehow.co.uk/m/how_7286799_set-vespa-carb...
1. Locate the idle set screw at the very bottom of the Tillotson carburetor. Turn it clockwise with a screwdriver until you completely close it without over-tightening the screw. 2...
http://www.ehow.com/how_8020281_adjust-tillotson-c...
1. Search the body of the carburetor to find the Tillotson model number. Since these are small carburetors, the model number may be separated into two sections and stamped on diffe...
http://www.ehow.com/how_7903599_identify-tillotson...
did you actually remove the carb jets and blow them out?...contact me via my avatar,ill send you a link for a manual...all you need to kown about setting/balancing carbs will be in...
http://uk.answers.yahoo.com/question/index?qid=200...
1. Open and disengage the choke, which should be done on a vehicle that has not been warmed up. Locate the choke butterfly and open it. Insert a wedge to keep it open while you cyc...
http://www.ehow.com/how_7827393_set-carburetor.htm...
Useful sites about:

Tillotson Carburetor Settings

Tillotson carb tuning - 2 cycle. This comes from an early, genuine Tillotson factory service brochure. It still applies today as a great starting point. ( Go to .. here ...
www.iwt.com.au
e-mail: sales@tillotson.ie ... carburetor prompted Tillotson to design and develop .... Note: IN MAKING CARBURETOR ADJUSTMENTS TURN ADJUSTMENTS ...
www.tillotson.ie
Tillotson - Carburetors and Filters ... Tillotson proudly supplies an extensive range of diaphragm carburetors to the ... •Independent/dependent fuel adjustment ...
www.tillotson.ie