‚Äč

How to Wire a Tachometer?

Answer

After market tachometers have a switch on the back of them to select 4, 6, or 8 cylinders. Make sure this switch is set to the correct position. Locate where you want the tachometer located and mount it. You should have four wires connected to the
source: answers.ask.com
Q&A Related to "How to Wire a Tachometer?"
1. Disconnect the boat's battery. 2. Strip 1/2-inch of insulation from both ends of all the wires. Use a pliers-type crimper to crimp ring connectors to both ends of the one of the
http://www.ehow.com/how_6914264_wire-boat-tachomet...
You don't have to connect it to the coil.Under the driver's seat, they is a single slot which is used for timing by the mechanic, you can just connect it to it. As for power for the
http://wiki.answers.com/Q/How_do_you_wire_a_tachom...
Red goes to the ignition switch fuse for power in the fuse box green goes to the the negative side of the distributor white is for the tachs light so it will go to the dash light
http://www.fixya.com/cars/t14721471-wire_tachomete...
Explore this Topic
Your car's tachometer tells you haw many RPMs the motor is making. the hookup basically involves hooking the tachometer wires to the ignition coils. ...
A person can wire a tachometer by locating a level surface for a vehicle. The tachometer wiring diagram can be utilized to run the wiring. Tie wraps will need ...
A Tachometer has three wires: positive, exciter, and ground wire. The positive wire connects to power source, the exciter wire is connected to the positive lead ...
About -  Privacy -  Your Cookie Choices  -  Careers -  About P.G. Wodehouse -  Articles -  Help -  Feedback © 2014 IAC Search & Media