‚Äč

How to Wire a Light Switch UK?

Answer

To wire a one-way light switch, first run a 2 wire ground cable from the breaker to the switch. Run another cable from the switch to the screw terminals on the light. Pull the cable through one of the holes in the box, leaving six inches exposed. Strip one-half inch of insulation from both white wires and join using a wire nut. Strip about one-half inch of insulation from both black wires. Connect one to each screw terminal on the switch. Mount the switch to the box using the included screws.
3 Additional Answers
When wiring a light switch the first step is to isolate the power from the mains power supply. Unscrew the cover plate and remove it from the switch box. Unscrew the terminals and remove the wires connecting them to the new plate using exactly the same terminals. Tighten the wires into place and screw the plate onto the wall box. Reconnect the power supply and the light switch will now be connected.
Start by ensuring that the switch is isolated from the mains power supply. Unscrew the small screws in the terminals, remove the wires and connect them to the new plate using exactly the same terminals. Ensure the wires are all firmly secured . Screw the plate to the wall box and reconnect the supply.
When wiring a light switch the first step is to isolate the power from the mains power supply. Unscrew the cover plate and take it out from the switch box. Unscrew the terminals and remove the wires, connect them to the new plate using exactly the same terminals. Tighten the wires into place and screw the plate onto the wall box. Reconnect the power supply and the light switch will now be connected.
Q&A Related to "How to Wire a Light Switch UK"
1. Turn off the electrical supply to your light switches by turning off the power in your home's electricity control or consumer box. The control box may be located in a kitchen cabinet
http://www.ehow.com/how_6599940_wire-light-switch-...
Learning how to wire a light switch is a skill that can come in very handy around the house. Following these instructions will help you to wire a two-way (on/off) switch for a light
http://www.life123.com/home-garden/electrical/wiri...
1. Locate the wires that originate at the magnetron. The magnetron is located underneath the engine flywheel on most tractors. The magnetron is a generator that uses the permanent
http://www.ehow.com/how_7919584_wire-lights-tracto...
1. Volt testers verify that power to the switch is turned off. Turn off the power to the circuit. The fuse panel houses either a circuit breaker or a fuse for each leg of power. Be
http://www.ehow.com/how_7294680_wire-light-two-sep...
About -  Privacy -  Your Cookie Choices  -  Careers -  About P.G. Wodehouse -  Help -  Feedback  -  Sitemap  © 2015 IAC Search & Media